Red Hat Commercial Linux 2.0 

You are at the LILO boot prompt.  If Linux is having trouble properly
detecting your hardware, try setting some hardware parameters here.

IDE Hard Drives                     hd[a,b,c,d]=cylinders,heads,sectors
Mitsumi CD-ROM                      mcd=port,irq
Sony 31&33 CD-ROM REQUIRED          cdu31a=base_addr,[irq|0][,PAS]
Aztech CD268                        aztcd=port
Ethernet Card                       ether=irq,base_addr,mem_start,mem_end
Bus Mouse                           bmouse=irq
SCSI Seagate ST0x                   st0x=base_addr,irq
SCSI Future Domain TMC-8xx          tmc8xx=base_addr,irq
SCSI Trantor T128                   t128=base_addr,irq
SCSI NCR-5380 Based                 ncr5380=port,irq,dma_channel
Adaptec 15{1,2}x, SoundBlasterSCSI  aha152x=port,irq,scsi_id,reconnect,parity
Adaptec 1542                        aha1542=base_addr
Buslogic                            buslogic=base_addr
Pro Audio Spectrum / Studio 16      pas16=port,irq
SoundBlaster Pro or 16 compatible   sbpcd=io_addr,{SoundBlaster,Lasermate,SPEA}
ATAPI/IDE CD-ROM Drives             hd{a,b,c,d}=cdrom
        (all addresses (not IRQs) should begin with 0x; ie. 0x340) 
Enter "linux <param> <param> ..." (or just hit ENTER to auto-detect).