Network Configuration

   Choose  your  network  card  and whether you would
   like to configure using DHCP. If you have multiple
   Ethernet  devices,  each  device will have its own
   configuration   screen.  You  can  switch  between
   device  screens,  (for example eth0 and eth1); the
   information  you  give  will  be  specific to each
   screen.  If  you  select  Activate  on  boot, your
   network card will be started when you boot.

   If  you  do  not  have  DHCP  client access or are
   unsure  as  to  what  this  information is, please
   contact your Network Administrator.

   Next  enter,  where  applicable,  the  IP Address,
   Netmask,  Network,  Broadcast,  and Point to Point
   addresses.  If  you are unsure about any of these,
   contact your Network Administrator.

   Note:  Point  to  Point  addresses  are  used  for
   configuring point-to-point connections for CTC and
   ESCON devices.

   Enter  in  a  hostname  for your system. If you do
   not, your system will be known as "localhost."

   Finally,   enter   the  Gateway  address  and  the
   Primary, Secondary, and Terti ary DNS addresses.
